RTS Buried Waterproofing is a premium waterproofing system to protect occupied spaces from water infiltration.
Perma-Gard III
Split-slab and below-grade urethane waterproofing system
System Overview
Perma-Gard III uses Neogard 7401 urethane to create a seamless waterproofing barrier. 7401 is easy to apply, and meets South Coast Air Quality Management District (SCAQMD) VOC requirements. This system requires a protection course; refer to the system Guide Specification for more information.
Use Area:
Split and below-grade slabs
Type:
Urethane
Features:
- Non-priming
- Excellent elongation
- High solids
- Low VOC
Benefits:
- Less labor
- Provides crack bridging/waterproofing
- Easy to achieve required film thickness
- Environmentally friendly
Propiedades físicas
Product | Description | Test Method | Results |
---|---|---|---|
7401 urethane | Tensile Strength | ASTM D412 | 250 psi |
7401 urethane | Elongation | ASTM D412 | 500% |
7401 urethane | MVT at 60 mils | ASTM E96 | 0.60 English Perms |
7401 urethane | Water Resistance | ASTM D471 | < 3% |
Technical Documents
Does Perma-Gard III require a primer?
No. A primer is not required, but a primer can be used if desired.
Does Perma-Gard III require a protection/drainage board?
For split-slab applications, a protection or drainage board is required.
Can Perma-Gard III be applied at 60 mils in a single application?
Innovacoatings recommends applying the 7401 urethane in two coats to reach 60 mils. This will ensure the 7401 cures properly.
Can the 7401 urethane be thinned?
Yes. The 7401 urethane can be thinned up to 10% using 08080 Hempel’s Thinner (xylene).
You can trust Perma-Gard III in your next project
High-performance protection tested under the harshest environments. Perma-Gard III was developed to endure intense pedestrian traffic while providing a seamless, durable protection against cracks and abrasion.