Skip to main content

Auto-Gard FC T

Two component, fast cure, low odor urethane system with an integrally textured, aliphatic topcoat

Auto-Gard FC T is a urethane system with an integrally textured topcoat. It provides a consistent, well-textured finish with good anti-slip characteristics. The integrally textured topcoat eliminates the need for silica aggregates, reducing health concerns from silicosis. This system is ideal for high production applications.

System Overview

Auto-Gard FC T’s low odor and fast curing allows for vehicular traffic 24-36 hours after installation. The full coating system can be installed quickly, and it is compatible with the most stringent VOC regulations. This system is ideal for work in or near occupied buildings where odor may be an issue.

Auto-Gard FC T is integrally textured—it has a synthetic aggregate suspended in the coating. Applicators can install these coatings without broadcasting silica quartz aggregate, eliminating a production step and allowing a higher rate of production over standard coatings.

Eliminating the broadcast step also removes the use of hazardous silica sand on job sites, while achieving a more consistent textured surface and improving slip resistance compared to a system with manual aggregate broadcast.

Saving time is key for applications like renovations and routine maintenance, which are typically completed during a facility’s down time.

Use Area:

Vehicular Traffic

Type:

Urethane

Features:

  • High elongation base coat
  • Reduced application steps
  • Integral aggregate top coat
  • No presence of silica

Benefits:

  • Provides excellent crack bridging properties
  • Increased production
  • No need to broadcast aggregate, consistent textured finish and reduced exposure to silicosis
  • Reduced health hazard

Selected Physical Properties

Product Description Test Method Results
Auto-Gard FC T system Dynamic Coefficient of Friction ANSI A137.1 0.71, dry surface
Auto-Gard FC T system Dynamic Coefficient of Friction ANSI A137.1 0.54, wet surface
Auto-Gard FC T system Fire Resistance ASTM E108 Pass

Auto-Gard FC T System Build

Coat Product Coverage Rate Mils WFT/DFT
4 - Topcoat FC7545/FC7964 70 sf/gal 23/20
3 - Double Texture FC7545/FC7964 90-133 sf/gal 13/12
2 - Base FC7500/FC7960 80 sf/gal 20/20
1 - Primer 7780/7781
7797/7798
300 sf/gal
300-500 sf/gal
NA

Technical Documents

How long does Auto-Gard FC T need to cure before opening to vehicular traffic?

Typically the coating needs to cure 24 hours before opening to vehicular traffic. In cooler temperatures this time may be 24-36 hours.

What type concrete curing compounds can be used with Auto-Gard FCT?

It is best to water cure concrete or use a sodium silicate curing compound. The use of acrylic or other “film forming” compounds will create bond issues and must be removed.

What is the minimum temperature at which Auto-Gard FC T can be applied?

The coating should be applied at temperatures that are 40°F/4°C and rising during application.

What is the maximum concrete temperature that Auto-Gard FC T can be applied?

The coating should not be applied to deck surfaces that are =/> 100°F/38°C.

You can trust Auto-Gard FC T in your next project

High-performance protection tested under the harshest environments. Auto-Gard FC T was developed to endure intense vehicular traffic while providing a seamless, durable, skid-resistance membrane to prevent the ingress of moisture and chloride intrusion. 

Contact Us